• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Engine paint yellowing

  • Thread starter Thread starter claygs750e
  • Start date Start date
C

claygs750e

Guest
Ok so last year I painted my engine using VHT silver and black paint with a clear coat. Two things happen that I would like to avoid this time around. 1. During me syncing the carbs the top end of the motor yellowed a bit which I think maybe it got too hot since I didn't take as many breaks as I should have. 2. I did have a float stuck and spilled gas on the back end of the engine which screwed the paint up. So I have the engine ready to paint again, but this time I bought the VHT header paint since it has a higher resistance to heat and maybe it can prevent it from yellowing? Is that a correct way of thinking or should I buy actual engine paint because it may be too high to cure? Also, should I avoid a clear coat on it in case that?s what got ate up by the gas and not so much the paint? The can says it's resistant to gas. Thanks
 
I had the same thing happen several years ago, I painted my 1000 engine with silver PJ1 and it yellowed after 1000 km's.

From my research the header paint is not the way to go. It contains ceramic which will prevent the dissipation of heat, not what you want. I contacted VHT and they said the same thing. They did however say to use the caliper paint instead as it has the fuel and oil resistance that is needed and doesn't contain ceramic.

I am not sure if they have it in the silver you want though. I painted my engine semi gloss black. It has held very well.

I am presently rebuilding a 1983 1100 which I have completely stripped down and refinished with Gun-Kote. It has been a learning curve with this paint but I have finally figured it out and am happy with the result. They do have it in silver. It however requires a total strip and blast for proper adhesion.

As for using the VHT I would not clear coat it. They are all single part air/bake cure and the clear will be no stronger than the base. If fuel is going to lift the paint it will lift the clear. Secondly you are just adding layers which will reduce the heat dissipation.

My opinion and experience,

cheers,
Daryl
 
Back
Top