• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Issues with Cylinder 3, Vaccum leak?

  • Thread starter Thread starter mortation
  • Start date Start date
M

mortation

Guest
I am having an issue with Cylinder 3. It doesnt get as hot as the other 3 and I get some sputter/backfire out of my right pipe.

Seems to run OK when the bike has been on the road for 15+ minutes but still sputters on sharp deceleration. I am thinking it is probably not related to coils, the problem doesnt appear move when I change the coil wire.

Valve gapping is write. Dont think it would be a timing issue. Has good compression so not likely a valve issue.

So I am thinking it may be a vaccum leak some place in the carb, a T perhaps? The boots and clamps are all new on both sides so they are not leaking. New air filter too.

Any thoughts or suggestions? I was thinking about cranking up the Fuel/Air screw just on #3 but I bet that will just hose my plug :P
 
#3 pot running cold

#3 pot running cold

sounds like you are missing a hose from #3 carb to back of your fuel tap (petcock ). I bought a '79 gs1000s (real deal) and previous owner(s) had removed it . I couldn't get it running properly & had same symptoms as yours. I left it off, blanked off both carby and fuel tap with short pieces of fuel line and zip ties. Boom boom , job done.
 
Mortation,

I am no expert but make sure you check this first since it happened to me. Check the resistance in your spark plug wires with and without the caps. Mine was doing the same as yours and the cap had shorted. Long shot but a $5.00 fix if that is all it is.
 
Back
Top