R
Raid3n
Guest
i recently bought a replacement stator for my '84 GSXR 400, got it all into the engine and now have run into a small problem.
the stock wiring had 3 bullet connectors for the stator instead of a clip, so i have no idea which wire was for which leg of the stator.. and which terminal on the reg/rec it connects to..
so my question is this, can i just arbitrarily hook up the leads for each of the legs and the reg rec will sort out which to use in which situation? or is there a specific a to a, b to b kind of setup?
any help is greatly appreciated..
for reference it's a 3 stage stator with a 5 prong reg/rec (power, gnd, and 3 prongs to stator)
the stock wiring had 3 bullet connectors for the stator instead of a clip, so i have no idea which wire was for which leg of the stator.. and which terminal on the reg/rec it connects to..
so my question is this, can i just arbitrarily hook up the leads for each of the legs and the reg rec will sort out which to use in which situation? or is there a specific a to a, b to b kind of setup?
any help is greatly appreciated..
for reference it's a 3 stage stator with a 5 prong reg/rec (power, gnd, and 3 prongs to stator)