Announcement

Collapse
No announcement yet.

1980 gs850 throttle issue

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    1980 gs850 throttle issue

    I think I have a couple things going on here that I can't seem to solve. (1) I have a new petcock that is vacuum controlled. Earlier I asked a question on it because it constantly ran. I was told to adjust the plastic valve in it to the vertical position. That seemed to work for the time being. Now it appears that it will run in vertical or horizontal position with no vacuum put to it. Is it faulty? (2) I just had the bike running great for a long period of time. stopped it and then went to restart a while later it runs but when I give it some throttle it bogs and then dies. That is why I checked the petcock again. Could the petcock be the cause of the engine bogging out under throttle?
    1980 GS850
    1977 CB550
    1977 CB750
    1875 GL1000
    1980 XS1100

    #2
    Is this an 850G or an 850GL?

    By your description of the petcock, I'm suspecting it's a GL.

    .
    sigpic
    mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
    hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
    #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
    #2 son: 1980 GS1000G
    Family Portrait
    Siblings and Spouses
    Mom's first ride
    Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
    (Click on my username in the upper-left corner for e-mail info.)

    Comment


      #3
      Gosh, always hated those stupid "80" model petcocks, thank goodness only one year. Only suggestion, run a fuel line from petcock, down into a jar or pan, see if you can turn the slot to somewhere that will stop the fuel flow, when, if, flow stops, that should be the run position. Turn it till fuel flows freely, that should be the pri. position. If fuel never stops, no doubt bad petcock. If you do find the on pos. also put a piece of hose to the vacuum port of the petcock, gently suck on the other end, very little vacuum opens it, quit sucking & fuel should stop. Good luck.
      1983 GS1100E, 1983 CB1100F, 1991 GSX1100G, 1996 Kaw. ZL600 Eliminator, 1999 Bandit 1200S, 2005 Bandit 1200S, 2000 Kaw. ZRX 1100

      Comment


        #4
        I am not totally sure the bike was fairly stripped down when i got it
        1980 GS850
        1977 CB550
        1977 CB750
        1875 GL1000
        1980 XS1100

        Comment


          #5
          Tried the extended gas line. the petcock runs freely in the vertical and runs under vacuum at horizontal. The bike was running great earlier today. It will start up and run only with the choke on now. Not really sure what to check next.
          1980 GS850
          1977 CB550
          1977 CB750
          1875 GL1000
          1980 XS1100

          Comment


            #6
            Originally posted by Steve View Post
            Is this an 850G or an 850GL?
            I just looked back in your previous posts. I asked you this same question in May, 2018 and you STILL have not answered it.

            Certainly you have found by now that it DOES make a difference which one you have. Especially with the things that were really different, like the fuel petcock.

            There were a few others, too, but there is no sense in mentioning them unless there is verification that you have an "L".

            .
            sigpic
            mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
            hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
            #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
            #2 son: 1980 GS1000G
            Family Portrait
            Siblings and Spouses
            Mom's first ride
            Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
            (Click on my username in the upper-left corner for e-mail info.)

            Comment


              #7
              The tag on the steering tube is torn off. I have the VIN how do I tell if it is a g or gl?
              1980 GS850
              1977 CB550
              1977 CB750
              1875 GL1000
              1980 XS1100

              Comment


                #8
                Several visual clues:
                1. front axle ahead of forks or inline?
                2. front fender chrome or painted?
                3. gauges individual circles or in one large, oval pod?
                4. handlebars rather tall and uncomfortable or mid-rise (might have been changed by previous owner)
                5. gas tank all round-ish (and about 3.5 gallons) or does it have beveled edges running the length (and about 5.8 gallons)?
                6. do your side covers say GS850L or GS850G?
                7. is the seat stepped or rather flat?
                8. is the rear fender chrome, with a tail light on top of it, or is is plastic, and under a plastic tail piece that also houses the tail light?

                The first half of each question would identify that part as an "L", the second part would be for a "G".

                The handlebars are commonly changed, as they are rather uncomfortable. The seat is sometimes changed, as it is uncomfortable as well. Most of the other items don't change easily, so would be good indicators.

                .
                sigpic
                mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
                hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
                #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
                #2 son: 1980 GS1000G
                Family Portrait
                Siblings and Spouses
                Mom's first ride
                Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
                (Click on my username in the upper-left corner for e-mail info.)

                Comment


                  #9
                  Thanks for the reply. It would be an "L".
                  1980 GS850
                  1977 CB550
                  1977 CB750
                  1875 GL1000
                  1980 XS1100

                  Comment


                    #10
                    I took my carbs off and cleaned them again.The bike does start and will idle and run fairly well when warm. When I give it some gas it has a sluggish response as get up to 3500 rpms. The bike has air pods on it no airbox it came to me that way. I have air screws out 3.5 turns. Any suggestions on getting to run better. thanks.
                    1980 GS850
                    1977 CB550
                    1977 CB750
                    1875 GL1000
                    1980 XS1100

                    Comment


                      #11
                      Check the newbie makes thread linked in my signature. Sounds like you have several classic issues which that thread will shed light on.
                      Ed

                      To measure is to know.

                      Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

                      Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

                      Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

                      KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

                      Comment


                        #12
                        Thanks I will.
                        1980 GS850
                        1977 CB550
                        1977 CB750
                        1875 GL1000
                        1980 XS1100

                        Comment


                          #13
                          Sounds like you've figured it out before I made this picture.
                          Attached Files
                          Current Bikes:
                          2001 Yamaha FZ1 (bought same one back)

                          Comment


                            #14
                            If your carbs were not rejetted for the air pods, then that may be your problem. You may have stock jets which work with the stock airbox.
                            Current Bikes:
                            2001 Yamaha FZ1 (bought same one back)

                            Comment


                              #15
                              Originally posted by yellowjacket View Post
                              I took my carbs off and cleaned them again.The bike does start and will idle and run fairly well when warm. When I give it some gas it has a sluggish response as get up to 3500 rpms. The bike has air pods on it no airbox it came to me that way. I have air screws out 3.5 turns. Any suggestions on getting to run better. thanks.
                              Find a stock air box, I think you'll be much happier.
                              sigpicMrBill Been a GSR member on and off since April 2002
                              1980 GS 750E Bought new in Feb of 1980
                              2015 CAN AM RTS


                              Stuff I've done to my bike:dancing: 1100E front end with new Sonic springs, 1100E swing arm conversion with new Progressive shocks installed, 530 sprockets/chain conversion, new SS brake lines, new brake pads. New SS fasteners through out. Rebuilt carbs, new EBC clutch springs and horn installed. New paint. Motor runs strong.

                              Comment

                              Working...
                              X