Scudder
Announcement
Collapse
No announcement yet.
GR650 bobber project
Collapse
X
-
Scudder
GR650 bobber project
I've been working on a 1983 hardtail bobber project for a while now, a little at a time. The compression is off in both cylinders. 120 in the left and 80 in the right. Bike started and ran pretty well, before I removed the motor to do some welding on the frame last Winter. Just curious how the compression could be off after removing the engine?
ScudderTags: None
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35640
- Torrance, CA
You running an open pipe on this bobber of yours? Rejetted the carbs appropriately?Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
-
Scudder
Suppose I should have mentioned.
1. Running PODS
2. Pretty much open pipes (cherry bomb mufflers)
3. Installed a rejet kit specifically designed for the set up.
No. I haven't checked the valve clearances. Suppose I'll start there.
Scudder
Comment
-
Scudder
Checked the valves. Two were off a bit. Adjusted them. The bike has potential life as it is chugging now, like it wants to start. Before the valve adjustment there was nothing. Just the starter. So... I think when I have some time I might be able get'er to start. Got to find some time first however.
I think a major issue is the proper air to fuel. PODS...
Scudder
Comment
-
Scudder
Comment
Comment