Announcement

Collapse
No announcement yet.

Not a GS question. but Yamaha electrical

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Not a GS question. but Yamaha electrical

    So I have been pretty busy and all of you know I am like as far away from understanding electrical stuff as anyone can be. So heres the newest symptom the 73 Yammy TX750 like to play.

    Dead cold starts and runs great. Get it warmed up and the left side looses spark. I have changed the condensor and put in new points thinking these may be the problem..WRONG!

    So now I am pondering whether the left side coil is going south when it gets heated up.
    MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
    1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

    NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


    I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

    #2
    There are not that many parts in a simple system like yours.
    If not any of the connectors, I would change out the coil.
    You can probably use any 5 Ohm coil.

    Comment


      #3
      Someone posted once about using an OHM meter to check them..How do you do that?? I dont know if Matts meter will work but I can give it a shot.
      MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
      1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

      NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


      I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

      Comment


        #4
        Can you just swap side to side as a test?

        It is common for coils to heat up and fail. When it fails, it the bad side coil hotter than the good side coil? If so it's likely shorting out inside.
        http://img.photobucket.com/albums/v5...tatesMap-1.jpg

        Life is too short to ride an L.

        Comment


          #5
          Originally posted by chuck hahn View Post
          Someone posted once about using an OHM meter to check them..How do you do that?? I dont know if Matts meter will work but I can give it a shot.
          According to BassCliff's site: "To test the coils put one probe of the multimeter on each of the terminals on the primary side of the coil. You should get 3-5 ohms. Check the secondary windings by placing one probe into each of the plug wires coming from one coil. You should get 30-50,000 ohms for stock coils and 15-20,000 for aftermarket."
          Although a different brand and different type, those readings should get you in the ballpark.

          Comment


            #6
            may check GOOD on all ohms test but real world it MAY ARC internally and poop out...

            Comment


              #7
              Originally posted by barnbiketom View Post
              may check GOOD on all ohms test but real world it MAY ARC internally and poop out...
              It could just as easily have a broken wire that loses contact when the coil heats up and expands.

              Either way, get readings when the coil is cool and hot.

              .
              sigpic
              mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
              hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
              #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
              #2 son: 1980 GS1000G
              Family Portrait
              Siblings and Spouses
              Mom's first ride
              Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
              (Click on my username in the upper-left corner for e-mail info.)

              Comment


                #8
                I havent taken the tank back off yet and started it to see if one coli is getting hotter than the other one. When this did it the first time I surmised the points on the left side had burnt so I replaced them and the plug had great spark so I put the plug in and it instantly started and ran on both cylinders so I took it for about a 15 miute ride and when I got home I thought it was running real rough and I pulled the left side wire again and it didnt change the sound..so I pulled the plug and again no spark.

                This is why I am suspecting a heating up coil which fails.
                MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
                1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

                NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


                I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

                Comment


                  #9
                  Like already suggested - swap the coils around and see if the problem moves to the RHS. If it does, it's the coil.
                  Current:
                  Z1300A5 Locomotive (swapped my Intruder for it), GS450 Cafe Project (might never finish it....), XT500 Commuter (I know - it's a Yamaha :eek:)

                  Past:
                  VL1500 Intruder (swapped for Z1300), ZX9R Streetfighter (lets face it - too fast....), 1984 GSX750EF, 1984 GSX1100EF (AKA GS1150)
                  And a bunch of other crap Yamahas....

                  Comment


                    #10
                    Heat index was only 93 today and I had the energy to tinker with the bike. What i found was that one of the points was out of gap once I had used the timing light and set the timing.

                    Fiddled with the points again and also found that the timing light was having an intermittent skip in flashes on the right hand cylinder. Cut a little off the end of the wire and rescrewed the cap on and that symptom was gone.

                    Set the engine fans up and the slave bottle and let it run for as long as it wanted to see if one of the coils was getting hotter than the other to the touch and the both felt about the same, so I dont think I have any over heating coils.

                    Bike sat and idled for well over 45 minutes and not even so much as a sputter. And both cylinders stayed lit. I left the fans on for a good hour to cool it down like it had been sitting for a long time and it fired instantly.

                    So far ( fingers crossed ) it seems all the issues are sorted. Yeah I know, I just jinxed the heck out of myself now!!!
                    MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
                    1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

                    NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


                    I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

                    Comment

                    Working...
                    X