Clutch actuator

[New GS guy]

Not sure if anyone else has already been over this in another thread but my clutch actuator I believe it is randomly let go of the cable lost the clutch needless to say so my question is does anyone have a picture of what it should look like or know of a place where I could source a new one for reference it is a 1985 gs300l. Thanks in advance

[Nessism]

Check the OEM parts fishe, such as on Partilla. The worm screw mechanism is same as the 450. They rarely fail. You may have some other problem. Did you pull the engine cover yet? If not, I'd do that. And make sure to use an impact driver on the screws or they may strip.

[New GS guy]

Yes I pulled the cover can't figure out how to upload a picture but the issue is the little riveted piece that the cable attached to broke and let go of the cable thanks for the info on it being the same as the 450. I checked partzilla and that didn't show any for a 300 I will look again for a 450. Is it the same as a 550 by chance I have one that I could borrow it from if so

[Nessism]

Partzilla shows this PN. I did a search on ebay and got a couple of hits...23200-44101

[New GS guy]

Thank you I will do some digging and see if I can find it with the pn will keep posted I have found a few complete covers with one still attached on eBay was just hoping to be riding again a little sooner than shipping can take there

[Gorminrider]

Not sure if anyone else has already been over this in another thread but my clutch actuator I believe it is randomly let go of the cable lost the clutch needless to say so my question is does anyone have a picture of what it should look like or know of a place where I could source a new one for reference it is a 1985 gs300l. Thanks in advance

Hi NewGS Guy..The cable end can fall out of these easily when cable is slack. It happens when you put the casing back on while lining it up to the Clutch Push pin ...so if you get a new one, use a bit of wire twisted cunningly to keep it all together while replacing cover... This might have been what B*ggrd original.

[New GS guy]

UPDATE:. Part is same on the 550 as well so I put the cable end and the actuator from the other bike in seems to be working fine put about 100miles on the bike yesterday and it worked fine (the adjustment on the back of the actuator was messing with me hard tho)