Announcement

Collapse
No announcement yet.

FINALLY have the money for a GS450 or a GR650.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    FINALLY have the money for a GS450 or a GR650.

    Merry Christmas ! I have been lurking here, on and off for years, with only a very few comments.
    1st: Is it safe to go to "gstwins" ? My browser keeps warning me not to?
    2nd: At this point in time, are there parts not available for the GS450 or GR650 that would keep me from riding for a few weeks? I'm not caring about body work such as side covers, fenders, cowl? I think it would be prudent to buy any parts that are especially hard to get ahead of time and keep on hand. Electrical components come to mind. I'm not adverse to utilizing used parts and I would probably be mechanically talented enough to jury rig some parts from other bikes.
    I own the Clymer GS450 manual now and will pick up a Haynes and a factory manual. I also intend to buy a parts bike since I will now have a 2 car garage.
    I am well aware that the GS500 bike is much easier to get parts for but I am willing to tolerate some inconveniences to ride the bike I want.
    Any input is welcome.
    Last edited by Boogywstew; 12-25-2024, 12:27 AM.

    #2
    You can upgrade the brakes on either if that snippet helps.

    Bwringer may be a good source of info on the GR650. Only thing of note I remember is bizarrely I think it has a slipper clutch.
    1980 GS1000G - Sold
    1978 GS1000E - Finished!
    1980 GS550E - Fixed & given to a friend
    1983 GS750ES Special - Sold
    2009 KLR 650 - Sold - gone to TX!
    1982 GS1100G - Rebuilt and finished. - Sold
    2009 TE610 - Dual Sporting around dreaming of Dakar..... - FOR SALE!

    www.parasiticsanalytics.com

    TWINPOT BRAKE UPGRADE LINKY: http://www.thegsresources.com/_forum...e-on-78-Skunk/

    Comment


      #3
      Originally posted by salty_monk View Post
      You can upgrade the brakes on either if that snippet helps.

      Bwringer may be a good source of info on the GR650. Only thing of note I remember is bizarrely I think it has a slipper clutch.
      No?15characters
      1983 GS 550 LD
      2009 BMW K1300s

      Comment


        #4
        Maybe the wrong terminology......

        - And the most unique feature on this engine: A "dual mass" flywheel with a centrifugal clutch that disengages above 3000 rpm. So light flywheel above 3 k for good acceleration, and heavy flywheel below 3 k for steady idle and smooth low speed running.
        1980 GS1000G - Sold
        1978 GS1000E - Finished!
        1980 GS550E - Fixed & given to a friend
        1983 GS750ES Special - Sold
        2009 KLR 650 - Sold - gone to TX!
        1982 GS1100G - Rebuilt and finished. - Sold
        2009 TE610 - Dual Sporting around dreaming of Dakar..... - FOR SALE!

        www.parasiticsanalytics.com

        TWINPOT BRAKE UPGRADE LINKY: http://www.thegsresources.com/_forum...e-on-78-Skunk/

        Comment


          #5
          Don't bother stocking up on parts. Search out a nice clean bike, then go from there. From my experience, it's worth paying more for a good starting point.

          I don't have any experience with the GR, but I wouldn't be afraid to buy one if it fell my way. They are quite rare, though. 450's are more common. One hassle with those bikes is carb parts. Suzuki changed the carbs over the years, and one version is hard to get parts for, the other is better. And while you say you aren't interested in a 500, they are a vastly improved bike over the 450; much newer tech. You can always make a project out of customizing the looks to match your desire. It's amazing what a cool paint job and small faring can do!
          Ed

          To measure is to know.

          Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

          Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

          Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

          KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

          Comment


            #6
            I understand the GS500 engine will fit in the GS450 frame with the exception of the head which has the exhaust ports angled differently and they would hit the GS450 frame. I've read here and other sites that the GS450 head will bolt right up to the GS500 engine, solving that problem. I thought carbs and various electrical components taken from the GS500 could be installed on the GS450, especially charging components? I have seen only one, in my opinion, customized GS500 that looked appealing. It was basically a stock GS500 with a non Suzuki small fairing where the bottom of the fairing was extended along parallel to the bottom of the GS500 gas tank. It was approximately halfway in size between a stock GS500F fairing and a stock GS450S fairing. This isn't the exact bike I was thinking of so apparently there are more than the one customized GS500 that I find appealing.
            Suzuki GS500 is a fairly popular medium-capacity motorcycle for everyday rides, this masterpiece was made in Portugal in the H2Moto garage.

            I only ride in the rain when I have to, but typically, it seems to happen no matter how I try to avoid it! My bike will keep it's fenders and the stock air cleaner under the seat behind the stock side covers like the Good Lord intended!
            Thank you for your response!!!
            Last edited by Boogywstew; 12-30-2024, 01:20 AM.

            Comment


              #7
              Originally posted by Boogywstew View Post
              I have seen only one, in my opinion, customized GS500 that looked appealing. It was basically a stock GS500 with a non Suzuki small fairing where the bottom of the fairing was extended along parallel to the bottom of the GS500 gas tank. It was approximately halfway in size between a stock GS500F fairing and a stock GS450S fairing. This isn't the exact bike I was thinking of so apparently there are more than the one customized GS500 that I find appealing.
              Dunstall style fairing, then.
              "Thought he, it is a wicked world in all meridians; I'll die a pagan."
              ~Herman Melville

              2016 1200 Superlow
              1982 CB900f

              Comment


                #8
                Personally I would lean towards a GS450. I owned a few GR650's and engine parts were tough to find. But the 450 is still easy to get almost all parts for. There are some parts from a GS500 that will swap right over (carbs, R/R, etc) to a GS450.

                What else are you looking for?

                Comment


                  #9
                  I want an air cooled Japanese twin or thumper with belt or chain drive and between 400 and 650 cc. That's the sweet spot for me. I would buy a late 70s model bike if parts weren't too much trouble to get. I have been looking at the Suzuki GS450, GS500, GR650 and the LS650 Savage - Boulevard 40S. I am turned off by forward controls and the lack of a center stand on the Savage. I've been researching center stands that would fit on the Savage but I've yet to find any instances where it's been done. I just turned 72 and getting my leg over a high saddle might be a problem so it makes me look twice at the Savage.
                  I'm also looking at Yamaha XS650s because I've had 5 of them and parts are still easy to obtain but they are relatively heavy at 470 lbs wet. I had a Kawasaki KZ 750B years ago but it was even heavier. I had a Yamaha SR500 years ago which I loved but any bike I buy now must have an electric starter. Kick AND electric would be perfect but they are rare nowadays.
                  The GS450 is looking like the best bet at this point but it could very well happen that I stumble over another bike that I never considered. Everything is a tradeoff it seems but it isn't always bad. I do all my own maintenance and all my own tire work. I've never had to adjust wire spokes or lace up a wheel but I can mount and balance tires.
                  My first and only new motorcycle was a 1980 Kawasaki KZ440 which I put 33,000 miles on in 3 years. I rode it from Central, FL to Central WY, Albuquerque NM to Lander, WY, Albuquerque NM to Central FL with no windshield or luggage. I had the self control to drive 12 hour days at a constant 65 and never had any problems with other motorists. Some times I'd speed up to keep from backing up traffic. The blow by from tractor trailers or even high winds never bothered me. Since the KZ440 was my first bike, I paid too much attention to other motorcyclist's remarks that my bike was a "girl's bike" and a "beginner's bike" (Which it certainly can be!). Years have come and gone and I have ridden thousands of miles on V-Rods, 1200 Sportsters and a few big BMWs. Now, through experience, I certainly know what I like. My KZ440 would have been a perfect bike at the time if I'd only changed the handlebars and the seat! My KZ440 was the "A" model which is very similar to the GS450L in appearance.
                  Last edited by Boogywstew; 01-05-2025, 10:15 PM.

                  Comment


                    #10
                    Splurge before it's too late...https://www.thegsresources.com/_foru...r-400-thoughts
                    Ed

                    To measure is to know.

                    Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

                    Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

                    Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

                    KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

                    Comment


                      #11
                      If I've learned one thing already it's that a few people will buy that bike and decide it's too small and/or under powered. I might consider a used one then? The street 400 market is heating up, what with the Royal Enfield Guerilla 450 and the Harley Davidson X-440 . Anyone here have personal opinions about the Yamaha Seca400? I didn't think it sold well in America and parts would be tough to find?
                      These Triumph, Harley and Royal Enfield models are helping sway my opinion that the GS450 is the right bike for me.
                      Last edited by Boogywstew; Yesterday, 06:37 AM.

                      Comment


                        #12
                        Finally, you have how much money? Do you want to work on a bike first or ride it? I like Ed's idea on that Triumph. I haven't seen a Yamaha Seca since the 80s. Suzuki GS's appeal to us here because they are sort of plentiful, cheap, and strong. GS450 or 500 would seem fine, if you can find one. There are new bikes like the Vitpilen (sorta weird looking IMO) that might be interesting. But except for my weakness for Ducati *err, too big displacement wise... I feel nervous about anything out of Europe other than Triumph in that displacement range. The Triumph is hitting the UJM marks for me. That H2 Moto looks good but that nuevo-cafe style has gotten so cliche, big NO to that brown seat. I don't know why but they bug me haha. Get off my lawn!
                        Last edited by oldGSfan; Yesterday, 11:06 PM.
                        Tom

                        '82 GS1100E Mr. Turbo
                        '79 GS100E
                        Other non Suzuki bikes

                        Comment


                          #13
                          I have over $5 K to use but I won't buy anything new. I'll let others take the hit on depreciation. I am living right now in Erie, PA in a house on the busiest road in the city and there is no garage, shed or even a basement. I'll be moving 41 miles away into a 14 X 68 mobile home with a 2 car garage in Northeast Ohio before February is out, maybe sooner. There's just me and my cat and the MH is surrounded by farmland on an acre of land with no residences in sight. I'm a musician so seclusion is important to me. I am a good neighbor. I can utilize a bedroom in the MH for hobby work and I can heat the garage. I don't mind working on a good used bike from now until late March or April but I want to be out riding when there is no snow on the roads. I usually ride in all 12 months. I have always done spectacularly well at buying used cars, trucks and motorcycles. I feel you when you mention the "nuevo-cafe" style being so cliche. That bike would be an inspiration but not a blueprint. Got to have a center stand, stock side covers and fenders that fender. I'll probably install a bikini or a dunstall fairing which will be a first for me. I've never had or wanted even a windshield. I was still wearing an open face helmet and goggles 10 years ago. My bike will almost certainly have a completely stock engine, especially the air cleaner and mufflers.
                          I have my eye on an '82 GS450T on Marketplace but the seller won't respond. It looks bone stock and in great condition with the seller claiming it needs nothing.

                          Comment

                          Working...
                          X