Announcement

Collapse
No announcement yet.

Idle issue with Video!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Idle issue with Video!

    I have a 81 GS450 L. CV carbs. It will get "Stuck" around 3 K then after 10 seconds it dips to 2 K but will not return back to 1,100 unless I blip the throttle a little bit. I have messed with the idle screws no difference. And I did check for air leaks. But I am pretty sure there is none because it idles at 1,100 just fine. I did also swap the CV slides. Here is a link to the vid I took tonight. http://www.youtube.com/watch?v=s37UB9_RWoY Thanks!

    #2
    I can't remember now but are your intake boots new? That really does look like an air leak to me... I know you evened out one of them but if your boots are anything like mine were they will all appear to be good and fine but they really aren't...
    1982 GS450E - The Wee Beastie
    1984 GSX750S Katana 7/11 - Kit Kat - BOTM May 2020

    sigpic

    450 Refresh thread: https://www.thegsresources.com/_foru...-GS450-Refresh

    Katana 7/11 thread: http://www.thegsresources.com/_forum...84-Katana-7-11

    Comment


      #3
      No they are not new. I might try this http://www.youtube.com/watch?v=mqJyZ...8&feature=plcp tomorrow. I have the gasket material. And I will use three bond 1194. My O rings will be here in a few days and its nice out out soooo. I want to ride! Also where do you get replacement clamps for the carb boots?

      Comment


        #4
        I'd seriously recommend forking out for new ones, about $25 each from Boulevard Suzuki.

        The reason for that is that the problem with my old ones was that the rubber had shrunk, so not only did it not seal well against the head, but the outside diameter was too small which prevented the clamps from clamping properly and the inside diameter was also too small which made it really hard to get them in. It also meant the rubber wasn't complying to the carbs very well, hence the leaks.

        The clamps are also available and are cheap.
        1982 GS450E - The Wee Beastie
        1984 GSX750S Katana 7/11 - Kit Kat - BOTM May 2020

        sigpic

        450 Refresh thread: https://www.thegsresources.com/_foru...-GS450-Refresh

        Katana 7/11 thread: http://www.thegsresources.com/_forum...84-Katana-7-11

        Comment


          #5
          I think I might have made it better. I used some thread sealer on the synch ports in the intake. It no longer hangs at 2 K. I should have the new O rings here is a day or two. So I will get those all replaced and see if its better. How long does it usually take for a 450 to warm up fully? Do you have to use the choke all the time?

          Comment


            #6
            Choke to start. Put on your coat, helmet, and gloves, drive down the street. A 100yds. on the street ease off choke.

            cg
            sigpic
            83 GS1100g
            2006 Triumph Sprint ST 1050

            Ohhhh!........Torque sweet Temptress.........always whispering.... a murmuring Siren

            Comment


              #7
              Sounds good

              Comment


                #8
                Really Charlie? I stick mine on choke while I put my helmet and gloves on and shut the garage door, then it's off the choke and off I go. Mind you it's possibly a little warmer here...

                Bakirkwold, glad to hear you're getting somewhere with it!

                As for getting the bike fully warm, it'll take a good 10 to 15 minutes typically to get it truly warm. Warm enough to idle with the choke off isn't fully warm. I made that mistake when initially setting my idle and mixture screws and I had it all way too rich due to it not being warm enough yet. It's still too rich now but that's a whole different story...
                1982 GS450E - The Wee Beastie
                1984 GSX750S Katana 7/11 - Kit Kat - BOTM May 2020

                sigpic

                450 Refresh thread: https://www.thegsresources.com/_foru...-GS450-Refresh

                Katana 7/11 thread: http://www.thegsresources.com/_forum...84-Katana-7-11

                Comment


                  #9
                  The new O rings fixed it. Or at least made a heck of a lot better. You where right guys! Thanks again.

                  Comment


                    #10
                    Originally posted by bakirkwold View Post
                    The new O rings fixed it. Or at least made a heck of a lot better. You where right guys! Thanks again.
                    Glad to hear it! I still say get new boots, but if it's working well then that's just plan excellent regardless
                    1982 GS450E - The Wee Beastie
                    1984 GSX750S Katana 7/11 - Kit Kat - BOTM May 2020

                    sigpic

                    450 Refresh thread: https://www.thegsresources.com/_foru...-GS450-Refresh

                    Katana 7/11 thread: http://www.thegsresources.com/_forum...84-Katana-7-11

                    Comment

                    Working...
                    X