Frozen bolt in behind clutch cover.

[Line_Producer]

Good evening everyone,
I was breaking down my bike so I could paint everything. While following the instructions in the manual to remove the engine, I came across this: <check picture>

It says to remove those two screws where the clutch cable is connected. Unfortunately, one of them is frozen. I already tried to get it out with a screw remover. No dice. So, do I really have to remove that screw to take out the entire engine?

2. How do I get the clutch cable out of the 'holder'? It seems to be one piece.

Thanks for your help.

-wil

[Calvin Blackmore]

cant you use progressively large drill bits to pop off the button head of the screw therby leaving only the screws shaft?

[tkent02]

Are you using an impact driver?
If not, you need one before you ruin another screw.

[Line_Producer]

impact driver

Thanks for the tips fellas. I"m off to pick up an impact driver at Home Depot this morning.

What is the function of that screw though?

[1948man]

http://www.homedepot.com/h_d1/N-5yc1vZ1xgs/R-100022376/h_d2/ProductDisplay?langId=-1&storeId=10051&catalogId=10053

This one worked for me when my cheaper one wouldn't