.png "Powered by vBulletin")
Is this normal for a '82 650? I have about 3/4 inch of play after removing my clutch plate cover. It also wiggles around. Thanx!
-
-
Is the big hub nut loose ? How does the washer look that locks the hub nut ? These are aluminum nuts that have been known to get loose. There is an APE billet nut for 25 bucks that should fix that. Best way to attack that is to have or borrow an impact driver.82 1100 EZ (red)
"You co-opting words of KV only thickens the scent of your BS. A thief and a putter-on of airs most foul. " JEEPRUSTY -
Its right in the middle of the 6 clutch springs. It has 6 notches on it that act with the exterior clutch assembly. According to clymer's, it called a "release rack", Thanx again.Comment
-
Sorry but not understanding the question. Some photos showing the problem would be helpful.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
YesOriginally posted by Rafe View Post
That's OK
It's just a pulling (outward) mechanism. Once you remove the rack, it just sits there loose
You'll see once you pull the pressure plate1978 GS 1000 (since new)
1979 GS 1000 (The Fridge, superbike replica project)
1978 GS 1000 (parts)
1981 GS 850 (anyone want a project?)
1981 GPZ 550 (backroad screamer)
1970 450 Mk IIID (THUMP!)
2007 DRz 400S
1999 ATK 490ES
1994 DR 350SESComment
Comment