.png "Powered by vBulletin")
I just remove my valve from my 83 gs1100e head to put on new seals and springs. What do I have to do before I put them back or replace them. Can I just put them back???????????????????/
-
Last edited by Guest; 11-02-2012, 09:54 PM. -
Read the service manual. -
Keep track of the valves and put them back where you got them.
Check the specs on the valves, guides and seats. You can find this info in your manual.1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
1985 GS1150ES stock with 85 Red E bodywork.
Comment
-
while they are out you could lap them in to make sure they are seating good and tight. liberally cover the stems and new stem seals with engine oil before refitting.
make sure you put the same valve back in the same position it came from.
also make sure the collets are seated good and proper on the valve after installation.
a few taps with a hard rubber mallet on the top of the valve will make sure they are seated correctly1978 GS1085.
Just remember, an opinion without 3.14 is just an onion!Comment
-
Valve change
Thanks for the infoComment
-
The guides are probably shot. Bring it over and we will check it out for youSpeed Merchant
http://www.gszone.bizComment
Comment