.png "Powered by vBulletin")
Just done a 530 chain and sprocket conversion on my Suzuki GS1000E 1979 model. Now running a 17 tooth front sprocket and 48 tooth rear, the bike is fitted with a Metmachex swinging arm. The clearance between the swinging arm and chain is close but acceptable, what I require is some kind of swinging arm chain protection slipper, does anybody have any ideas of what I can use to protect the swinging arm, has anybody fitted something similar?
-
-
get some acetal sheet from ebay, shape it to fit with hacksaw or jigsaw and sand it smooth and rivet it on, or use good double sided adhesive tape if you dont want to drill your arm.
it will wear out eventually so buy enough to make 2 or 3 strips so you can just replace it when it wears.
Last edited by Agemax; 04-14-2013, 07:26 PM.1978 GS1085.
Just remember, an opinion without 3.14 is just an onion! -
Thanks Adrian, just checking ebay now for some of the delrin stripComment
-
see my post again i edited itOriginally posted by gs79 View Post
1978 GS1085.
Just remember, an opinion without 3.14 is just an onion!Comment
-
Splendiforous, cheers
and only 14 miles from us!
Comment
-
250 x 250 you should get at least 8 suitable sized pieces from that. keep you going for a while!1978 GS1085.
Just remember, an opinion without 3.14 is just an onion!Comment
Comment