.png "Powered by vBulletin")
Well the money pit is now up and running well; time to put the tank and fairing on and RIDE. I want to retorque the head gasket before installing the tank, the bike has been through 4 heat cycles. My question is retorque hot or cold? Thanks
-
-
You will want to reset the valves and retorque the head with the engine "stone cold". -
I would guess cold, just because that's how it was torqued originally. If you used a fiber gasket with a metal core you will need to do it again, I did after about two hundred miles. My experience is the all metal ones saeem to need it only once after assembly.
Ride onComment
-
I suggest retorque at regular intervals until the torque fall-off stops. If you used OEM gaskets this should occur after a couple retorques. If you used Athena (green base gasket), good luck!Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
Nope used OEM gaskets as suggested by everyone here. ThanksComment
Comment