Announcement

Collapse
No announcement yet.

Head removal success!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Head removal success!

    Managed to pull the head off tonight. Only broke one bolt, the one in the cront of the engine (upside down) and one nut refused to come off the stud and took the whole stud with it! Lol...went slow took lots of pics which i will upload tonight. Thanks to all on the board, i searched a whole lot of posts during the teardown!
    Well i tore into it tonight. Broke one bolt, easy fix..



    Found a bad connection on the 1-4 coil, could be why i was fouling #1 at higher revs.
    Only was held on by a few strands...












    Last edited by mvalenti; 07-24-2013, 09:33 PM.
    -Mark
    Boston, MA
    Suck Squeeze Bang Blow..
    sigpic
    1980 GS850G with 79 carbs.....

    #2
    Nice! Cams look in good shape.

    Comment


      #3
      It looks like I'm about to do the same thing on my '81, so I'll keep up with your thread. Nice pics.

      Comment


        #4
        Just clean everything real good. A side note ! The replacement head gasket may not use the square O ring in the middle. If the gasket overlaps the O ring area do not use O ring

        Comment

        Working...
        X