.png "Powered by vBulletin")
I just did a top end rebuild not long ago. I'm weeping oil in the center of my head betwen the head and base where the small bolt that goes into the head is. I used copper gaskets for the head and base and yes I sprayed them. I have retourqued the head and replaced the orings on head nuts 1 & 3. Any ideas or am I stuck pulling it all off again?
-
-
My copper gaskets weep a little oil.
Unless you had everything machined perfect they may weep a little.
Is it wrappping around the engine and getting on you?1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
1985 GS1150ES stock with 85 Red E bodywork.
-
Not getting on my but if I'm in traffic to long it starts burning off.Comment
Comment