Cheers
Announcement
Collapse
No announcement yet.
1981 GS550E (x) clutch cable
Collapse
X
-
1981 GS550E (x) clutch cable
Hi All, new to the forum with a new (old) bike. I have a 1981 GS550 E(x, I think) in need of a new clutch cable. The local spares place has the cable for the 1980 GS550E. Could someone tell me if this part would be suitable or point me in the direction of a resource to check these things? I've had a look at some on ebay to see if they are interchangable and have had mixed results.
CheersTags: None
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35618
- Torrance, CA
Check the part numbers for interchangeability...http://www.boulevardsuzuki.com/oempa...ian=MotorcycleEd
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
-
dapeel
Thanks for your help.
Strangely, my bike isn't listed on the sites I've looked at. I wonder if it wasn't widely sold (I'm in South Africa). I'll phone the local Suzuki office and see if they can provide any info.
Comment
-
OK, I looked, your bike has the same clutch release parts as the older 550s. This means cable for the 1978 550 will work, but the length may be slightly off if they changed handlebars for your year. If your bars are about the same as the older bikes it will be fine. If you want I can measure the cable length on my 78.
This is the 1978 clutch cable:
58200-47000 CABLE, CLUTCH | B,C&EC,N&EN
I found a picture of your 1981, the bars look identical to what mine came with, the cable should be fine.
Last edited by tkent02; 01-02-2014, 10:07 AM.
Comment
-
dapeel
My bike actually looks more like this, with a rear cowl over the tail light and lower bars. Here is a pic of my bars. I've removed my cable and measured it, and will compare it to what they have in the shop for the older models. (1175mm outer sleeve + adjustment area against case. ~125mm inner cable, but hard to get too accurate due to break). I'll keep you updated. Once again, thanks for your help
Comment
-
I think th one from a 550S is what you want, for that little bit shorter. I think it's a 58200-43400, but not sure. If you get it can you send me the measurements? I need one slightly shorter for the other 550.
Edit, it might be this:
58200-47700
From a 1982 550M Katana
I think I'll just buy one of each and measure them all.Last edited by tkent02; 01-02-2014, 01:52 PM.
Comment
Comment