Announcement

Collapse
No announcement yet.

Gs1100ez timing chain tensioner

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Gs1100ez timing chain tensioner

    Hey guys, just trying to figure out if installing a full manual timing chain tensioner is a good or bad idea. I just reinstalled my stock tensioner after a head gasket reseal and Im hearing the chain at idle slightly. I am use to cars and knowing what's normal or not and this to me is not but correct me if I'm wrong. When I say timing chain noise I mean a very slight chain slap type noise mind you only when I first started the bike for only 1 or 2 minutes

    #2
    Originally posted by Gs1100e82 View Post
    Hey guys, just trying to figure out if installing a full manual timing chain tensioner is a good or bad idea. I just reinstalled my stock tensioner after a head gasket reseal and Im hearing the chain at idle slightly. I am use to cars and knowing what's normal or not and this to me is not but correct me if I'm wrong. When I say timing chain noise I mean a very slight chain slap type noise mind you only when I first started the bike for only 1 or 2 minutes
    Did you release the plunger after you put it in?
    http://img.photobucket.com/albums/v5...tatesMap-1.jpg

    Life is too short to ride an L.

    Comment


      #3
      I will also ask, but in different words: Did you install it properly?

      1. Retract the plunger, use setscrew to lock it in place.
      2. Mount tensioner to cylinder block.
      3. Loosen the setscrew to release the plunger.
      4. Tighten the setscrew on the plunger, then back it off 1/4 to 1/2 turn, NO MORE.
      5. Use the locknut to hold the setscrew in that slightly-backed-off position.

      .
      sigpic
      mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
      hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
      #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
      #2 son: 1980 GS1000G
      Family Portrait
      Siblings and Spouses
      Mom's first ride
      Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
      (Click on my username in the upper-left corner for e-mail info.)

      Comment


        #4
        I am almost sure I did it correctly but I might just do it again to make sure. I'd hate to find out the hard way. Thanks for the help

        Comment


          #5
          Did you lock the piston while pushing it in?
          Then release it with a good 1/4 turn and lock it down without tightening it?
          1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
          1985 GS1150ES stock with 85 Red E bodywork.

          Comment

          Working...
          X