and where is the best place to get a better clutch nut at ? ,
Announcement
Collapse
No announcement yet.
82 1100 g
Collapse
X
-
82 1100 g
I have a 82 1100 g , I found the clutch nut about to fall off , tighten it up , but the motor still has a rattle or knocking at idle , not as bad as before the retighten of the nut , so is the springs or ??? anyone willing to give info ,
and where is the best place to get a better clutch nut at ? ,Last edited by Guest; 06-09-2014, 09:36 PM.Tags: None
-
tbirdhd
need help with this, as stated check clutch nut and spring ., pulled flywheel is was tight , starter clutch is tight , what else can make it knock till you raise idle some ???
Comment
-
rwnielsen
Comment
-
LarryJ
I had to replace my clutch hub nut with an APE hub nut. The '82 hub nuts & final drive splinters are made from material that I'd just plainly too soft. Your job nut with not hold torque & continue to slip threads until you replace it.
Comment
-
rwnielsen
Comment
Comment