on a positive note I found the timing was late and after adjusting it the bike runs better.
Announcement
Collapse
No announcement yet.
GS650G crankshaft oil seal
Collapse
X
-
GS650G crankshaft oil seal
My GS650G has developed a leak at the seal on the crankshaft behind the pickups. This is a 3 inch diameter seal which appears to be pressed in. The FSM offers scant information on this seal, in the assembly process it just shows the seal appearing on the engine after the halves are joined. I'd like to know if anyone has pulled and replaced a seal like this, what tool they used to extract it and if any special procedure is needed.
on a positive note I found the timing was late and after adjusting it the bike runs better.1981 GS650G , all the bike you need
1980 GS1000G Power corrupts, and absolute power corrupts absolutelyTags: None
-
I replaced one of those when I had my 750E and looks like I'll have to replace it soon on my 850GL too.
This is one of the easier seals to replace. Once all of the ignition stuff is unbolted and out of the way, drill a small hole or two near the outside of the seal, thread in a wood or drywall screw, and pull. On my 750, there was plenty of solid aluminum behind the seal so I just turned the screw until the seal popped out.
There may be case sealant around the old seal. At least one engine-building expert here said that applying new sealant is not really necessary. Just grease up the new one and drive it in. I tried rigging up a seal pusher thing but was never able to get it to drive the seal in straight. Instead I resorted to tapping it in gently and evenly with a small light hammer. It did not leak.
It can help to put a slight chamfer on edge of the hole where the seal slides in, if there isn't one already. Totally optional, it will just keep the outer rubber coating of the seal from tearing as the seal is pressed in. (Just make sure you get all of the aluminum chips out, of course.)Last edited by eil; 08-08-2016, 12:37 PM.
-
Originally posted by eil View PostI replaced one of those when I had my 750E and looks like I'll have to replace it soon on my 850GL too.
It can help to put a slight chamfer on edge of the hole where the seal slides in, if there isn't one already. Totally optional, it will just keep the outer rubber coating of the seal from tearing as the seal is pressed in. (Just make sure you get all of the aluminum chips out, of course.)1980 GS1100E, the latest of many.
Comment
Comment