Announcement

Collapse
No announcement yet.

Inlet & Exhaust valves for GS850

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Inlet & Exhaust valves for GS850

    The OEM engine valves for a GS850G work out at around $640 (Australian) for a set of 8.
    OK, I know they are not real dollars to some of you folks but still very expensive.
    Has anyone found another source, equivalent or blank valves for this job?
    Last edited by uteman; 08-16-2016, 08:33 AM.

    #2
    Buy some on ebay and have them shipped. If money is tight find some from a low mileage bike and have them ground on a modern centerless valve grinding machine.
    Ed

    To measure is to know.

    Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

    Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

    Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

    KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

    Comment


      #3
      Same problem in NZ. Depending on fluctuations in the exchange rate, I have occasionally found it's easier/cheaper to go to a local head shop and get stainless blanks cut to suit. Shop here charges $58NZ for Manley blanks then plus cutting and groove machining.

      Comment


        #4
        Originally posted by GregT View Post
        Same problem in NZ. Depending on fluctuations in the exchange rate, I have occasionally found it's easier/cheaper to go to a local head shop and get stainless blanks cut to suit. Shop here charges $58NZ for Manley blanks then plus cutting and groove machining.
        GregT: Thanks for responding. We sure get the high prices compared to USA

        Comment

        Working...
        X