Announcement
Collapse
No announcement yet.
Clutch/gears
Collapse
X
-
Clutch/gears
Finding it difficult to select neutral sometimes also when in neutral a bit clunky going into first gear,could this be selector forks and do both generally go at the same time.If they are gone can they be replaced without stripping engine.ConanLast edited by angus; 02-08-2017, 11:24 AM.1983 GS 650 gl
1982 GS 850 gl
1980 GS 550L
1982 GS 650 G(KATANA)
Gsx 1400 daily rideTags: None
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35617
- Torrance, CA
Shift fork changing requires splitting the engine. Just open your factory manual and take a look at what's involved.
More likely the issue is related to excessive clutch drag. Did you adjust the clutch to reduce free play and then see if that helps? If not then I'd plan to check the clutch plates to be sure they are flat...or just replace them. Both steel and fiber.
On my old GS1000 the clutch would drag making it difficult to find neutral. After replacing the clutch plates the issue completely went away.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
-
Originally posted by angus View PostWhen you say adjust the clutch do you mean the cable.I've replaced the cable and have no play in it at allsigpicMrBill Been a GSR member on and off since April 2002
1980 GS 750E Bought new in Feb of 1980
2015 CAN AM RTS
Stuff I've done to my bike:dancing: 1100E front end with new Sonic springs, 1100E swing arm conversion with new Progressive shocks installed, 530 sprockets/chain conversion, new SS brake lines, new brake pads. New SS fasteners through out. Rebuilt carbs, new EBC clutch springs and horn installed. New paint. Motor runs strong.
Comment
Comment