.png "Powered by vBulletin")
If the valves werent VERIFIED to be adjusted at or before that 9,500 miles and you havent done them then at 12, plus they are way overdue.
-
MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550
NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.
I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it. -
i had the same problem with rotella once. for some reason i doesn't read well cold, and not all of it comes out in a oil change. if you worm it up first i had better luck. It was so bad during a change once i had to bump the starter several times to get it all out.Comment
-
I just read these posts and saying to myself Really? Yes cold oil is going to be a bit harder to read full, once you get the bike up on the center stand or even level off the side stand, it is going to take the cold oil a few seconds to reach it level point. Warm oil well find its level quicker. Yes cold oil is harder to drain. That is why you warm the motor up before an oil change. Hot/warm oil flows faster drains better. The type of oil has no effect on volume, like it was stated volume is volume. a 10w-30 is gonna have the same fluid volume as a 20w-50.sigpicMrBill Been a GSR member on and off since April 2002
1980 GS 750E Bought new in Feb of 1980
2015 CAN AM RTS
Stuff I've done to my bike:dancing: 1100E front end with new Sonic springs, 1100E swing arm conversion with new Progressive shocks installed, 530 sprockets/chain conversion, new SS brake lines, new brake pads. New SS fasteners through out. Rebuilt carbs, new EBC clutch springs and horn installed. New paint. Motor runs strong.Comment
Comment