.png "Powered by vBulletin")
I have a 82 gs850g and I swapped cylinder heads. I cleaned all and am in the process of lapping the valves. I reassembled the valve, new guide seals etc, but can't get the bucket Back in. I don't want to force them back, I tried lubricating but the won't fit back in, any suggestions would be greatly appreciated. Thanks
-
-
Maybe throw the buckets in the freezer for a while then try again. -
The clearance is VERY small. If the bucket is the slightest bit off-axis, it will hang up.
BE GENTLE.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.)Comment
-
All the above - plus it is possible for the valve spring or retainer to be installed off-center and stop the bucket going down the bore.
Usually, this is visible - and a tweak with a screwdriver will move it into position.Comment
-
Ok, thanks for the info.Comment
Comment