Cooley replica replica colours

[suzukijo]

http://oldskoolsuzuki.info:80/patrick/projects/knarf_gs1000/roberto_pietri_79/index.htm

i just stumbled on to this site, maybe some reference to this thread.

[rudy]

Hi guys, I can't thank you enough for the help you've already provided for this.

I just got another email from Brian. He has a request for a few more measurements if you could help us out. Here is the message from Brian:


For the Fuel Tank, I am looking for the following information;

* See attached pics, I am looking for a dimension (in mm) from the bottom edge of the tank, to the bottom edge of the white stripe, measured along the surface, at both front and back of the tank.
* Also a measurement for the starting edge of the SUZUKI along the surface as shown in the pic.
* Is it possible to get a higher res picture of the tank SUZUKI? I am also looking for a dimension of the thickness (in mm) if possible to the nearest .25mm for each of the black and white borders.

For the fender, I am looking for the following information;

* Dimensions as shown in the Picture115. I know this isn't the correct model, but am looking for the dimensions to the bottom of the white stripe, and the dimension in between the black stripes on your version.


He's also looking for a high quality picture or scan of the side cover writing. I guess he doesn't have any fonts that are close to it, so he has to draw it all himself.

[sharpy]

Oh u must mean me then. Do it soon promise

[rudy]

Oh u must mean me then. Do it soon promise

I wish there were more people to help out. At your convenience, sir!

[rudy]

Anybody with a GS1000S can help out

Brian is still looking for a good quality digital pic, or preferably a scan of the "GS1000S" on the side cover and the "SUZUKI" on the tank. This will work for ANY 1000S. Blue, Red, Aussie version, everywhere else version, doesn't matter. Open to anyone. Just needs to be the biggest resolution possible. PM me for the email address to send to.

The overall length to the nearest 1/4mm would also be a great help for him to scale it.

Thanks for all your help guys!


Oh, still need the measurements for the fender up there ^^^ too.

[rudy]

Ok, everything for the decals is done except for the front fender. Brian is just looking for the width between the stripes, and the distance from the bottom edge. Can be any version of the S, not just the red/white one.