Announcement

Collapse
No announcement yet.

Removing fender by lisinceplate

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Removing fender by lisinceplate

    :twisted: I was wondering if anewone could tell me how to remove the rear fender he one the lisince plate is atached to like in the galories to get a more agresive look
    Tags: None
    #2
    What bike do you have?

    Comment

      #3
      :twisted: 1981 GS650E

      Comment

        #4
        A dremel, a fiberglass cutting wheel, about 15 min.

        Comment

          #5
          :twisted: speeeeeeeeeeeeeeeed is awesome

          Comment

            #6
            no one said speed was bad :twisted: . but it does kill

            Comment

              #7
              I just used a hacksaw to cut the whole thing off, and some sandpaper to tidy up the job. then had a bracket made to fit the plate just under the stop light. Rather than fitting extra license plate lights I chopped out a section on the bottom of the stoplight and replaced it with clear plastic, works fine.

              Comment

                #8
                jd you got a photo?
                78 GS1000 Yosh replica racer project
                82 Kat 1000 Project
                05 CRF450x
                10 990 ADV-R The big dirt bike

                P.S I don't check PM to often, email me if you need me.

                Comment

                  #9
                  I used a air tool and a 3 inch cutting disc.....
                  buzzz...zzz......zzzz whiszzz
                  it sounds like a bad day at the dentist

                  Comment

                    #10
                    no one said speed was bad . but it does kill
                    It's a blatent, simplistic lie - don't fall for it.

                    Comment

                    Previous template Next
                    Working...
                    X