Bar end mirrors.. Covering the stock mount hole?

[Guest]

OK for those who have gone with bar end mirrors what did you do with the bolt hole where the stock mirrors went?

I was going to get some stainless button head screws to fill em in but I can't find a 10Mx1.25 thread button head bolt to fit the hole..

All I can get in that size is a standard hex bolt.

[Runningdog]

I got a couple of plastic plugs from Yamaha, that were intended to cap off those holes if not used...go to the dealer, only a couple of bucks.

[Baatfam]

I found a couple of large, plastic screws at AutoZone, I think....the threads weren't correct, but who cares...its plastic and screwed right in...

I think you can see them in this picture...

[Sparky]

depending on your bars you could also add a stud to hang your helmet on if you can find the right thread

[Maddog209]

I added mirrors and still haven't addressed the stock mount holes. But now I'm off to the store to find plastic plugs. Thanks guys!!

[kingofvenus]

1100gk's had plugs in them, also Honda gl500 silverwings.

[sschering]

Good to know.. thanks


I wonder if these will work

http://www.widgetco.com/hole-plugs-covers-10MM-black

[Bill C.]

Plastic Plugs

The 1000s used plastic plugs in the stock mount holes. Got mine from Bike Bandit when I ordered some parts.