Z1 bolt kit

[PoppaDre]

Just wondering are the 16 identical bolts in the kit to replace to valve cover bolts of the same size? Also appears there are no bolts for thr ignition cover. And there are a few extra smaller sized ones not sure where they go

[Flaming Chainsaws]

What I did was pulled the old bolts off one at a time. Compare the old bolt to the Z1 bolt. If it's the same, put it on the engine then repeat for all of the other bolts.

[cal_look_zero]

My kit was the same way. I had to hunt and choose, ended up having to buy the points cover bolts elsewhere. Had 3 small screws that fit the threads but were too short.

Those 16, I think only 8 go in the valve cover, rest go in the other covers.

[Flaming Chainsaws]

My kit was the same way. I had to hunt and choose, ended up having to buy the points cover bolts elsewhere. Had 3 small screws that fit the threads but were too short.

Those 16, I think only 8 go in the valve cover, rest go in the other covers.

It must be different between the GS850 and GS1100E. My Z1 bolt kit came with the clutch cover, signal generator cover, stator cover, sprocket cover, starter motor cover, and valve cover bolts.

Actually I am unsure of the valve cover bolts but I have A LOT of left over bolts that are the exact same size.

[afholderman]

It must be different between the GS850 and GS1100E. My Z1 bolt kit came with the clutch cover, signal generator cover, stator cover, sprocket cover, starter motor cover, and valve cover bolts.

Actually I am unsure of the valve cover bolts but I have A LOT of left over bolts that are the exact same size.

Are your left over bolts for the oil pan? My stainlesscycle kit came with those and if I remember correctly they were close to the same size.