backing plate for side cover badges

[Guest]

Anybody got a source for the little metal plates that push down on the badges pins? missing one. Will swing by a boneyard in Sarasota if it is still working next week if I cant source some.

[Steve]

Many of us use Parts Outlaw, which might not be too far from you. It is in Deland, which is between Orlando and Daytona.

If you look on the parts fiche, look on the Frame Cover fiche, you will see them. Parts Outlaw has a flat-rate shipping charge of $9.99 most of the time, but occasionally they run an un-advertised special. When you get to the checkout window on the website, enter the word BANG in the promo box, see if it works. In times past, shipping has been free, $1.00 or, more recently $1.50. My last order was a couple months ago and it worked then, but I have seen reports that it is not working at this time. Good luck.

.

[Mosquito13]

Thanks they have them . Code doesnt work, 9.99 shipping for a 1.75 part. will check the boneyard first, but I will need one.

[Steve]

When you decide to order, be aware that it will be about two weeks before you receive your order. I was told by another dealer that they have to have a minimum order before they place an order with the warehouse. I think that minimum was about $500. If you happen to be one of the last orders that puts them over that magic mark, it might be a few days quicker, but they have to place their order with the warehouse. The warehouse has to gather all the parts form the various corners of the storage area, then ship it to the dealer. When the dealer receives the order, they have to separate it out to all the different orders that they need to fill, then finally get it sent to you. Yep, takes about two weeks.

.

[JTGS850GL]

Thanks they have them . Code doesnt work, 9.99 shipping for a 1.75 part. will check the boneyard first, but I will need one.

Yep, looks like the BANG code is not working again. Time to give them a call and suggest its restoration.

[zakdaddy99]

I work as a parts manager at an Acura dealer. I used 90672-SW5-003 on mine. You can get them at any Honda or Acura dealer. MSRP $1.48.

[steve murdoch]

That is interesting, zak.
A small plastic nut/button as opposed to a metal clip.

https://www.oemacuraparts.com/oem-parts/acura-nut-push-2-4mm-90672sw5003

[80GS850GBob]

I'd think a local ace or true value might have a flat push nut in the nut and bolt section.

[Tom R]

Or 3M double sided tape on the back of the badge and don't bother with them. It's held mine on for the past 15 years or so.

[Mosquito13]

got one off a side cover at the boneyard. Put some automotive 3m trim tape also . Should be good for another 35 years.