Announcement
Collapse
No announcement yet.
GS 400 carburetor 'rubber' manifold to engine spacers, which way round ??
Collapse
X
-
GS 400 carburetor 'rubber' manifold to engine spacers, which way round ??
The 'diamond' shaped spacers that are pushed back in between the carb rubber manifolds and the engine when the carbs are refitted have a raised section in the bore, do these need to be a specific way round ie at a bottom corner or a top corner ??? ...? any info gratefully receivedTags: None
-
Forum GuruPast Site Supporter
Super Site Supporter- Jun 2018
- 5590
- Mifflinburg, PA / Land of Tar & Chip
Using the Search function, I found this thread with the same question, and an answer from a very knowledgeable, trusted, experienced member.
https://www.thegsresources.com/_foru...lators-spacers
Is this what you’re asking about?
Oh, and, welcome to the forum.Last edited by Rich82GS750TZ; 10-06-2022, 04:00 PM.Rich
1982 GS 750TZ
2015 Triumph Tiger 1200
BikeCliff's / Charging System Sorted / Posting Pics
Destroy-Rebuild 750T/ Destroy-Rebuild part deux
Comment