.png "Powered by vBulletin")
I have a 1979 GS1000 and don't have enough slack in my throttle cables. I took the carbs and throttle components apart to clean them. Prior to this the throttle cable was plenty long enough. The cable fits but the sliders are wide open. I am wondering if I messed up assembling them.
-
-
Here is a photo of the top of the carb -
Another view of the carb.Comment
-
As mentioned in your other thread about carbs, those are not the original carbs. This photo, unlike your other, do show mechanical slide carbs. You should buy a set of stock carbs, then rebuild them.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
No wonder the throttle cables didn't fit. Yikes.Comment
-
Keihen keyhole carbs! It's a Honda conspiracy.Comment
-
Cable looks attached in the wrong spot (threaded section), and going the wrong way around, and the end in the wrong hole.
But that's from just looking at what I can see in the photos...Comment
Comment