.png "Powered by vBulletin")
Well, I'd gone through #1 and #2 without much trouble (got to the air screws no problem after some guidance here) and what did I find in #3? UGH- ugly mcnastiness!
I'll post a picture upon removal from the dip, but one of the drain bowl towers is broken (surprisingly functional, i think) and the biggie: the pilot jet is all buggered up. a PO or mechanic left it in there too long/didn't use the right size screwdriver, and messed up the head.
I've got PB down the hole as well as the dip, so maybe by some miracle i'll have a chance at removal before the head is completely unusable.
Anyone have a suggestion on "jet removal"?
should i leave it and run it as is? this is what it looks like was done previously...
should i attempt to drill it out and replace?
if i attempt option 2, and completely mess up the jet tube, where would i find a replacement #3? i have a hard time believing they're just "kicking around" some auto parts store!
call it a rant, but now i'm afraid to even look at #4's internals...
I'll post a picture upon removal from the dip, but one of the drain bowl towers is broken (surprisingly functional, i think) and the biggie: the pilot jet is all buggered up. a PO or mechanic left it in there too long/didn't use the right size screwdriver, and messed up the head.
I've got PB down the hole as well as the dip, so maybe by some miracle i'll have a chance at removal before the head is completely unusable.
Anyone have a suggestion on "jet removal"?
should i leave it and run it as is? this is what it looks like was done previously...
should i attempt to drill it out and replace?
if i attempt option 2, and completely mess up the jet tube, where would i find a replacement #3? i have a hard time believing they're just "kicking around" some auto parts store!
call it a rant, but now i'm afraid to even look at #4's internals...
Comment