Announcement

Collapse
No announcement yet.

Save me

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Save me

    From putting 3 rounds of buckshot into my bike.
    It runs a few days ago both pre fire and post fire.
    - Carbs have been completely cleaned, new o rings etc etc dip yeah.
    - New pilot air screws 3 turns out, even 2 turns nothing (havent had a chance to adjust them yet)
    - Pods... still started fine before with them but I have new mains on the way and will raise the needles.
    - Have spark and compression all 4 cyl/ plugs
    - Fresh fuel being put in via gravity fed funnel off handle bars protected by an inline valve for my safety and no where near the battery (Never again!)
    - Floats are stopping fuel flow when bowls are full.
    - No loss of power to the coils
    - No airleaks and vacuum port is capped.
    - Choke works properly.
    - Valves are all adjusted
    What am I doing wrong/ missing.
    Seriously I cant afford to take it to a shop and I'm running out of time and patience.
    Last edited by Guest; 11-18-2010, 06:37 PM.

    #2
    What's wrong with it?
    http://img.photobucket.com/albums/v5...tatesMap-1.jpg

    Life is too short to ride an L.

    Comment


      #3
      It wont start..

      Comment


        #4
        Won't crank?
        Won't fire?
        Won't stay running?
        http://img.photobucket.com/albums/v5...tatesMap-1.jpg

        Life is too short to ride an L.

        Comment


          #5
          Wont fire. You can hear when I give it a little throttle it starts puffing like it wants to turn over but just wont.

          Comment


            #6
            You only need three things for an internal combustion engine to run:
            1) a proper air/fuel mixture
            2) sufficient compression
            3) a properly-timed spark

            Evidently you are missing one of them.

            The trick is finding out which one.

            .
            sigpic
            mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
            hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
            #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
            #2 son: 1980 GS1000G
            Family Portrait
            Siblings and Spouses
            Mom's first ride
            Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
            (Click on my username in the upper-left corner for e-mail info.)

            Comment


              #7
              You indicate that you have spark and compression on all 4 cylinders... that leads me to believe it is either a fuel delivery issue or a fuel/air ratio issue. The forum member will hang me for suggesting this but... maybe try a touch of starting fluid... just to see if it will make it go for a second... that would confirm that the issue is with the fuel.

              Comment


                #8
                Well my last theory is maybe it is my ignition timing, which I do not know how to do. Everything else I can handle...

                I know I don't have the ideal F/A Mixture yet because I cannot get it running yet.

                Comment


                  #9
                  Started for a second, then died and am in the same boat as before. Any ideas?

                  Comment


                    #10
                    its possible hat you ingested some trash into the carbs at some point. pull the bowls and look at whats there. clean the pilot jets too.

                    if this is your 85 GS700, the timing is non adjustable.

                    Comment


                      #11
                      You may have to elaborate for the lad Steve.

                      Originally posted by Steve View Post
                      You only need three things for an internal combustion engine to run:
                      1) a proper air/fuel mixture You had a fire you must have gas. is it in the carbs ?
                      2) sufficient compression Pull the plugs and put your finger over the hole while cranking
                      3) a properly-timed spark Are the plug wires in the right spot ? If you have a spare plug you can check for spark by connecting the spare plug and shorting it against the engine.
                      82 1100 EZ (red)

                      "You co-opting words of KV only thickens the scent of your BS. A thief and a putter-on of airs most foul. " JEEPRUSTY

                      Comment


                        #12
                        Install a new set of plugs.
                        sigpic

                        82 GS850
                        78 GS1000
                        04 HD Fatboy

                        ...............................____
                        .................________-|___\____
                        ..;.;;.:;:;.,;.|__(O)___|____/_(O)|

                        Comment


                          #13
                          Bowls are clean, gas is clean and plugs are clean.
                          I just started for a second while holding the starter then it continued to try and start.

                          Not to mention the carbs are completely clean and my tank has no debries in it whatsoever.

                          Comment


                            #14
                            Are the plugs 'NEW'?
                            Not clean, new..
                            sigpic

                            82 GS850
                            78 GS1000
                            04 HD Fatboy

                            ...............................____
                            .................________-|___\____
                            ..;.;;.:;:;.,;.|__(O)___|____/_(O)|

                            Comment


                              #15
                              does a float bowl worth of gas come out of each carb when you drain them one at a time?

                              Comment

                              Working...
                              X