What carbs do I have??

[Octane80]

So one thing that has bothered me since owning my gs750 is that the carbs are not the same as what I find in the manual. I always figured it's just a minor change for that particular run. Anyhow, the physical difference is that underneath the carb no fuel mixture adjustment screw exists, the needles are all slightly different, they have two fuel taps between carbs 1 and 2 then carbs 3 and 4, and the top cap on the carb is different from all the other I've seen. When I get home tonight I will pull what numbers I can find off them, but I wondered if anyone might be able to recognize them.

[Octane80]

Ok I looked em over tonight and couldn't find any other letter/number on them besides mic on one side and mikuni kogyo Japan on the other. I took a couple more pics maybe that will help.

[tkent02]

Frog carbs.

[Big T]

Well, those are not 26SS carbs

What do the bottoms look like?

2 fuel taps? Sounds like those are the vents

[Nessism]

Those don't look like VM Smoothbore carbs either. Maybe from a Kawasaki?

[Octane80]

I'll have to get a pic of the bottom tonight, they are not the smooth bores. This is getting kind of interesting now... when I bought the motorcycle I noticed some holes in the rear rim and was told by a friend they use to do that and drive a screw in to prevent the tire from spinning on the rim during drags. So far everything else has been stock in appearance besides the 4 to 1 kerker, pods, and possibly now this.

[Octane80]

Just found them, thanks for the tip on Kawasaki as these look identical to carb pictures from a z1.

[Adler]

[Octane80]

Ok, this gets even more interesting as the pic just posted by adler is the exact carb minus the float bowl. I looked up the 75 z1 and found the top to be the same then found the bowl to be the exact same as the 76 kz900. Mine has the side screw on the float bowl. So it appears to be a vm 28 of some sort...

[Adler]

Like this?

[Big T]

If it's a Z1 carb set, it will have an accellerator pump on #2

[Octane80]

That is it Adler what is the model of that carb? and it has no accelerator pump on 2.

[hampshirehog]

They're furriners from a Kawasaki. No fuel screws - too complicated for Kwacker owners.....

[Adler]

Here's all the info you can need on that set of carbs...

http://www.z1enterprises.com/reference/z1-carb-guide.aspx

On the bottom of that page it has settings and whatnot, though I suspect they may not be applicable to you.

[Octane80]

Thanks for the help fellas, it's def. the late model vm28sc. I already had tuned them by ear and synced them but it will be nice to have the factory sheets on them.