I am going to be running stock pipes with pods. (Bike didnt come with the stock box, otherwise I would just run it stock)
My research shows that I can use APE filters in the 42mm variety, PN 005-122 which will work on the VM 44mm body.
1. My findings seem to show that I should run a 120 or 115 main, since stock I have a 100 main. But I could only find this for people running pipes and stock box, is the same true for pods+stock pipes?
2. Looks like a 20 pilot and needle raised one notch will work fine as well. When raising the needle, does that mean moving it towards the "needle tip" so there are more notches on the top than the bottom?
3. All the carb rejetting recomendations I have found relate to the CV carbs and not the VM carbs. Are they the same?
4. After taking my carbs apart, I found that my pilot air screws were set at 3/4, 3/4, 3/4 and 1-3/4 turns to bottom. Shouldnt they all be at 1-3/4 turns, roughly?
5. My pilot fuel screws were set at 2-1/2, 2-1/2, 2-1/2 and 2. What the heck do those need to be?
6. My jet needle clips are not in the middle like they should be for stock carbs. They are in the second from top (away from the sharp tip). The needle is also stamped 5DL36. Is that a stock needle?
Sorry, I know its another newb with carb questions.
Comment