Starting problem

[Walter]

Enrichment circuit was the problem fired right up as soon as I got carbs on WOOT! now I have to readjust air/idle was idling at 2500 rpm at start up

[Walter]

Dodik, when you check your circuit again hold a flashlight at bottom of well and look thru top of jet you should be able to see straight down and if there is any debris, think what got most of mine clean was compressed air thru top side of jet, helps to have a reducer on air nozzle

[Dodik]

i got mine to start as well it was float height for me when i cleaned mine i guess i made two mistakes one i set floats to 24.2 instead of 22.4 and second i measured from the gasket now it starts but will idle too high even with the screw all the way out.

[Walter]

i got mine to start as well it was float height for me when i cleaned mine i guess i made two mistakes one i set floats to 24.2 instead of 22.4 and second i measured from the gasket now it starts but will idle too high even with the screw all the way out.

make sure your throttle cable isnt to tight