Motad NETA exhaust baffles

[BristolGSX]

From reading various articles on this great site, I know that you basically have to hack this system up & reweld to sort out a rattling baffle as it is not a 'repackable' system.

My question is, has anyone, say, cut the pipe just after the collector section/just before the silencer starts and then obtained a link pipe to clamp onto the cut pipe?

My measurements show a 57.9mm diameter if the pipe were cut there, so you would need a 59mm link pipe and then a 58 or 60mm end can/silencer to finish the job - with some fabrication on the end can mount I suspect.

Just an idea to throw out there as it is rattling in my mind to do this!

[Agemax]

you can buy all sorts of tailpipes on ebay, standard modern bikes or performance pipes. it is so easy to graft one on your existing pipe if you have access to a welder, or someone who welds