.png "Powered by vBulletin")
bowls needed
hi i have a 1978 gs 550 that i just bougt an i got it running but the inside left and outside right carb will leak allot from my over flows.and the inside right pours gas out in the air box side.come to find out the preveas owner pinched the inside tips of my over flows an now there split down the middle.an now i need four new bowls .or could i weld/sodder?
-
-
You should be able to clean up the brass and solder it just fine.
Just make sure you don't solder the tubes closed.
Remember that the key to a good solder job is to CLEAN the work.
Scrub those tubes until they SHINE, then apply some flux and heat.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.)
Comment