Intake O ring size for an '80 GS1100E?

[Sojourner]

Was going to order the rings I needed from cycleorings.com but his a snag.

The intake O ring sets are 40mm, 38mm, 32mm, and 30mm. My manual says my carbs are 34mm... So which should I order? Again these sizes are listed for the *INTAKE* rings, not the actual carb o rings. I've already got the BS CV o ring kit in the cart.

Now the bonus question- I might as well grab the stainless fastener kit as well. Anyone know which size I need for my bike?

THANKS!!

[GateKeeper]

lets see if this helps

77-79 750's, 850's and 1000's use 32mm o-rings and 16mm screws.
79 425's use 40mm O-rings and oddball 6x35 screws, which I don't carry. **
77-79 550's use 28mm O-rings (which I don't carry) and 16mm screws.
80 & 81 1100E and 750's don't use intake O-rings or screws (so you're off the hook!)
80 & 81 1000's use 40mm O-rings and 16mm screws. **
80 and later 850's use 38mm O-rings and 20mm screws.
81-83 650's use 38mm O-rings and 16mm screws.
80-82 550's " "
80-82 450E's use 40mm O-rings and 20mm screws.
82 & 83 1100's (2-valve) use 40mm O-rings and 16mm screws.
83-86 550's use a siamesed setup; they take 30mm O-rings, and five 16mm screws and one 20mm screw. There's a 'medley' screw set on the order page for these bikes.
85 700 uses 38mm O-rings and 20mm screws

unless I got it wrong ?

[Steve]

lets see if this helps
80 & 81 1100E and 750's don't use intake O-rings or screws

unless I got it wrong ?

No, you got it right.

And Sojourner has a little more money for his next project.

.

[Tom R]

You have a different type of carb holder - No o-rings.

[GateKeeper]

See,,,hang around here long enough and you do learn something.....LOL

.

[Sojourner]

Gatekeeper- Where did you find that list? I'm hoping I didn't miss it somewhere, but it's likely seeing as how I'm WFH and trying to order bike parts at the same time...

[GateKeeper]

part way down this page

http://cycleorings.com/intake.html

just after the hand holding the bad O ring

.

[Sojourner]

In the words of Homer Simpson...

DOH!!

Anyway, the rings are now ordered. Thanks all!

[koolaid_kid]

Actually, that information is incorrect. It should say:
80-83 1100E models do not use o-rings. Hehe.

[7981GS]

Check your intake manifolds (tubes) for cracking UNDER the clamps.

Eric

[sedelen]

Actually what you have are called "pipes" intake Right hand and left hand,
items 23 and 24 on this fiche.

http://www.boulevardsuzuki.com/fiche_section_detail.asp?section=95889&category=Motorcycles&make=SUZUKI&year=1980&fveh=2155