Pods, Pipes, Panic! (Help! Your Bike has Pods)

[swampig]

That would be correct the inner cyls need to run a little richer as it helps with the cooling you may also find tho that the rings wear a little faster but its negligable and will possibly not be noticable on a normal mildly tune bike

[Yozzer74]

Hi my bike is gs550ex c.f. carbs custom 4into2 pipe k&n pod filters. I've got denoted kit stage 3kit on needle set on 4th notch down 155 main jets .bike runs crap feels like it's not getting fuel .had it on dyno and this was the results .20180613_162333.jpg

[TxGSrider]

Hi my bike is gs550ex c.f. carbs custom 4into2 pipe k&n pod filters. I've got denoted kit stage 3kit on needle set on 4th notch down 155 main jets .bike runs crap feels like it's not getting fuel .had it on dyno and this was the results .[ATTACH=CONFIG]55284[/ATTACH]

Looking at that chart it looks lean. Personally I would use all the same size main jets instead of using larger on the inside cylinders if youre using pods. If you buy larger mains, remember that the DJ mains are sized differently. This can help http://www.jetsrus.com/FAQs/FAQ_miku...ihin_sizes.htm

[red1100]

I’m getting ready to rebuild the carbs on my 83 1100E. Last time they were off was in 1984 when the exhaust and pods were put on. This will be the first actual rebuild.So the jetting is spot on but is anything changed or updated significantly since then? Have my bottle brush looking carb cleaners and am ready to go. I’m right at 45,000 one owner miles.

[Big T]

Guys,

This sticky is an informational thread for you to read

DO NOT post up your questions or experiences here

Start a new thread below for your problem or question

[mike10]

Thats the coolest thing I ever saw

oh, hell yeah! i got your dinojet right here!

[Piers Pitcher]

Hello Newbie here.

Has anyone had success with finding a replacement exhaust for a 1981 GS1000G?

[ironbiker]

P.S: and remember always adjust the valves...FIRST