drilling out the slide hole

[Guest]

hey guys, anyone know what size the drill bit is to drill out the slide hole, thats in the jet kits?

i have a lil to much pressure on mine and i dont want to go to big of a hole, since there 100 each slide, any help is appreciated

[kingofvenus]

Dynojet kit for your bike lists a #30 bit for slide hole, that is .1285 in.

[Steve]

i have a lil to much pressure on mine and i dont want to go to big of a hole, since there 100 each slide, any help is appreciated

Would you mind taking a moment and translating that to English?

A little too much pressure on your what??

Since there are 100 of what on each slide?


By the way, you should also know that the hole does not go STRAIGHT through the bottom of the slide, it is an an angle.

.

[SqDancerLynn1]

You can also plug the holes with JB weld if necessary & then re drill

[platinum2]

thanks for replys.
$100 or more for new slides
to much down force/air pressure, they dont lift as well as needed
yea the holes are on a angle i have a junk set i looked at close