Announcement

Collapse
No announcement yet.

Clear coat spray after painting carbs

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Clear coat spray after painting carbs

    I'm finishing the painting of my carbs, kept them silver color. Should they be clear coated or not, I used dupli-color engine enamel.
    does everyone clearcoat their caps and bowls after polishing too?

    #2
    I just splash mud on mine and call it good.
    http://img.photobucket.com/albums/v5...tatesMap-1.jpg

    Life is too short to ride an L.

    Comment


      #3
      Originally posted by tkent02 View Post
      I just splash mud on mine and call it good.
      lol, just wanta make sure I do it right & not miss a step...

      Comment


        #4
        Unless you use a proper catalysed urethane clear fuel will eat it anyway. It's probably easier to touch it up without the clear.
        http://img.photobucket.com/albums/v5...tatesMap-1.jpg

        Life is too short to ride an L.

        Comment


          #5
          Originally posted by tkent02 View Post
          Unless you use a proper catalysed urethane clear fuel will eat it anyway. It's probably easier to touch it up without the clear.
          OK then, sounds good to me you guys mess around with the bowls after polish?

          Comment


            #6
            Originally posted by tkent02 View Post
            Unless you use a proper catalysed urethane clear fuel will eat it anyway. It's probably easier to touch it up without the clear.
            What he said. Fuel will eat rattle-can clear.
            I painted all my tins with the same paint (duplicolor engine) and clear you're using, and even after several coats of heavy duty insulator wax, it will only fend off fuel splashed/drips for a few seconds, and it still will leave a spot. A little polishing compound takes the spots out, but if it stays on there long enough to bubble the paint, you're out of luck.

            Comment


              #7
              I just leave the parts polished and wipe em down when you clean the bike with some good polishing compound

              Put any information that you have to make your bike look great in here.


              Comment


                #8
                I would recommend trying Spraymax 2Kand clear over the paint you shot. I used Duplicolor base and Spraymax clear over it, on a previous build, and it held up to fuel, wonderfully. And, Spraymax now offers a system where a shop can custom mix colors and put them in a can for you, all in 2Kpaint. I chose this method to custom shoot my daughter's BC Rich guitar in Plum Crazy Purple, and it went on great and is holding up even better.

                Comment


                  #9
                  I just used the Spraymax 2k clear over a gas tank I painted with duplicolor cans.....good stuff.
                  David
                  1998 Suzuki Bandit
                  1978 GS750 gone but not forgotten
                  1978 GS1000 - gone
                  1981 GS850 - gone

                  Comment

                  Working...
                  X