GSXR 36mm

[chef1366]

As a future project I have a set of Gixxer 36mm carbs. 88-92?
I have acess to DJ kits, other kits and stock emulsion tubes, jets, jet needles and ........
I'm running GS1150 36mm carbs with 47.5 pilots, 150 and 147.5 mains, jet needle on the fourth up from the bottom.
I have a 1230 set up with an 83 1100 head with 1.5 over SS intake valves and a slight street port.
I'd like to get as close to Plug and Play as possible. Any suggestions?

[chef1366]

Oh and I'm running a V&H 4-1 and K&N pods with the Gixxer carbs.

[49er]

Bill, are those Gixxer carbs Mikuni Sling Shots? If so you won't need to go as much over stock on your mains, as you would normally, when running pods!

Try your DJ needles in the same position as the stock ones, and 1-2 sizes up on the pilots.

Not getting enough out of the 1150 36 mm's?. It will be interesting to see how Sling Shots perform on your longer stocked, lower revving motor.

[chef1366]

Bill, are those Gixxer carbs Mikuni Sling Shots? If so you won't need to go as much over stock on your mains, as you would normally, when running pods!

Try your DJ needles in the same position as the stock ones, and 1-2 sizes up on the pilots.

Not getting enough out of the 1150 36 mm's?. It will be interesting to see how Sling Shots perform on your longer stocked, lower revving motor.

Yup, Sling shot carbs.
The stock GS1100 mains/pilots or the mains/pilots in the GSXR carbs?
The GS DJ needle or the GSXR DJ needle?

[49er]

Yup, Sling shot carbs.
The stock GS1100 mains/pilots or the mains/pilots in the GSXR carbs?
The GS DJ needle or the GSXR DJ needle?

Gixxer DJ's and mains/pilots. It's still going to be "suck and see" though!