.png "Powered by vBulletin")
I've only dipped one carb so far and it occurs to me that the needle valve's screen has a hard plastic that holds it in place. I have removed it from the dip and it appears fine (after about an hour and a half sitting in there). Should I dip the other needle valves?
-
-
Take the screen off the float seat.
The needle valve can be dipped.
Take the screen off with a small screwdriver into a towel so it doesn't land in the next county.1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
1985 GS1150ES stock with 85 Red E bodywork.
-
Removing Needle Valve screen
I'm assuming the screen just pops off prying it off with a little screwdriver but they don't seem to want to come off, don't want to crack the plastic.Comment
Comment