Help please

[Guest]

1982 gs750t. I just cleaned my carbs. I dipped them for 8 hours each, i cleaned every hole with a wire. I set the air screws to 2.5 each. The bike doesn't want to start. I finally got the bike started and it wants to ideal at 4k. When I add throttle in short burst it will rev up. If I keep the throttle on it will die. I got the battery tested and it's good. What should I do?

[earlfor]

Did it start, run and idle normally before you cleaned the carbs? Did you disassemble the carbs COMPLETELY? Did you replace all the rubber "O" rings in the carbs?

[Agemax]

double check you have cleaned the carbs properly AND reassembled them correctly,make sure the float bowls are filling with fuel, and,make sure you have no air leaks

[azr]

I see you posted a week ago about low voltage at your coils, did you get that fixed?

[Master077]

I took the carbs off because the bike would not start. Before this problem the bike would idle perfect. I replaced all off the orings.

[Master077]

I did a coil relay mod and now I am getting 11 volts at coils when starting bike. I also installed new spark plugs

[azr]

Did you do a near perfect bench synch on the carbs? or better yet have you had them vacuumed synched?

[tom203]

Doesn't want to start??? when you cleaned the carbs did you pay attention to "choke" circuit passages ? if it takes off to 4k, maybe the "choke" is sticking open -check cable for proper adjustment

[Master077]

I did a bench sync. I used a safety pin to make sure they were all the same. Could I of sync the carbs to open? I got the orings from cycle orings .com

[Agemax]

try turning the idle screw down, until it idles at a reasonable speed. it may start better then as well

[Master077]

I double checked the choke passages. Maybe I missed something

[Master077]

I just checked the idle screw. I unscrewed the idle screw and nothing changed. If I apply choke it idles at 6k

[Agemax]

have you connected the vacuum hose to the carbs correctly?

[Master077]

I didn't put the air box back on yet. That might effect the throttle? !

[Master077]

have you connected the vacuum hose to the carbs correctly?

I connected the hose the way they were when I took them off