.png "Powered by vBulletin")
I have reinstalled the carburetors and air box after a full tear down, cleaning, and o-ring replacement. Attempting to start the bike for the first time should happen soon.
I did bench sync the four carburetors best I could before the reinstall. A question now on performing the vacuum sync once it is up an running.
Noticed today after cramming all of these parts back into the frame that there is not a lot of room. In particular the access to the synchronization screw between the no. 2 and 3 carburetors is completely blocked by the choke and throttle cable brackets.
Would you remove the chock cable bracket once the bike is warmed up to gain access?
Thanks,
Dave P.
I did bench sync the four carburetors best I could before the reinstall. A question now on performing the vacuum sync once it is up an running.
Noticed today after cramming all of these parts back into the frame that there is not a lot of room. In particular the access to the synchronization screw between the no. 2 and 3 carburetors is completely blocked by the choke and throttle cable brackets.
Would you remove the chock cable bracket once the bike is warmed up to gain access?
Thanks,
Dave P.
Comment