.png "Powered by vBulletin")
Hey errbody, I've been hibernating too long!
Anyway, I'm getting ready to repack the Dime City mufflers on the bike, and while I was at it I pulled the headers off to swap the header bolts for studs. Looking inside the pipe, it gets REALLY small, like a pipe within a pipe small - where I cut the pipes to slip my part store special 1 3/8"-1 3/4" OD adapter pipes onto, I cut probably the last half inch of the other end of the inner pipe off.
Now I know this is a small engine, probably displaces less than the typical cup of coffee. So it isn't gonna exhale as much. But I can't stop wondering if a pipe without the inner pipe would increase power any since I've put on straight-thru mufflers, larger "intermediate" pipes(those adapter pipes between the mufflers and headers), pods, and dialed the jetting in accordingly?
I understand that might mean yet another rejet, which is fine since I need to raise the float level on the starboard carb anyway. Thanks for any input yall may have!
Anyway, I'm getting ready to repack the Dime City mufflers on the bike, and while I was at it I pulled the headers off to swap the header bolts for studs. Looking inside the pipe, it gets REALLY small, like a pipe within a pipe small - where I cut the pipes to slip my part store special 1 3/8"-1 3/4" OD adapter pipes onto, I cut probably the last half inch of the other end of the inner pipe off.
Now I know this is a small engine, probably displaces less than the typical cup of coffee. So it isn't gonna exhale as much. But I can't stop wondering if a pipe without the inner pipe would increase power any since I've put on straight-thru mufflers, larger "intermediate" pipes(those adapter pipes between the mufflers and headers), pods, and dialed the jetting in accordingly?
I understand that might mean yet another rejet, which is fine since I need to raise the float level on the starboard carb anyway. Thanks for any input yall may have!
Comment