gs 1000 carbs

[Guest]

Looking for info on the mikuni carbs on this gs1000. Looking into ordering a carb kit and not really sure what all i need. Im not sure what year it is as its not in the original bike. I believe it to be a 79........thanks
IMG_20160721_193133679.jpg

[chef1366]

I have everything to rebuild those.

[ccriley6]

I have everything to rebuild those.

Pm sent...........

[ccriley6]

Is this a decent set of sync guages for the money? Anyone have experience with them
s-l400.jpg

[steve murdoch]

The Morgan Carbtune is the preferred carb guage.

http://www.carbtune.com/carbdtls.html

[uk gs nut]

I have a set of those gauges pictured. they work fine, only problem is the pipes are not very good. I replaced mine with silicone pipe and they are more flexible.

[ccriley6]

Ordered a carbtune...thanks guys

[ccriley6]

What were the factory size main jets for the vm26 carbs? Mine appear to be 112.5.
Say i wanted to run some k&n pods, would a bigger jet and needle height change be necessary? The clip on the needles are in the middle slot.

[ccriley6]

What were the factory size main jets for the vm26 carbs? Mine appear to be 112.5.
Say i wanted to run some k&n pods, would a bigger jet and needle height change be necessary? The clip on the needles are in the middle slot.

Bump............

[Agemax]

standard mains are 95. if you want to run pods and you have a 4 into 1 exhaust then go for a Dynojet stage 3 kit.

[ccriley6]

I assume this is what yall refer to as a 4 to 1 pipe
IMG_20160821_125826706.jpg

[DohcBikes]

Oh my god it's so awesome

[ccriley6]

Oh my god it's so awesome

Thanks.....its not the fanciest but works. Its the "poor boy" version....lol
Most all the others i run with are running newer fuel injected gixxers and busa's.
I currently have all the sheet metal off and am in the process of setting valves and adj carbs. I just got the carbs cleaned and put back on.

[hannibal]

The mains ranged from 97.5 to 105. See the chart below.
GS750 carb specs.jpg

[ccriley6]

Got the carbs cleaned and put back together, i now have some popping at slight throttle....around 2-3k rpm on up. Where to start......