VM26 Carb Nipples

[Guest]

Hey guys,

So I have an issue. I dipped my carb nipples in the berryman's , and may or may not have forgotten about them for a little longer than I should have. When i got them out and started scrubbing them with a nylon brush, the once smooth coating decided it was going to give up on life, and washed away. Now I am left with an abrasive and what I can only assume is a raw surface.

Question 1: Are these FUBAR, and just need to be replaced, or despite their scrubbed away surfacing, can they still be used?

Question 2: While searching the part numbers needed for these, I have found out that everywhere seems to be sold out of these. So, what are usable parts for these (after market) or is there another carb nipple that will fit my VM26's?

Question 3: Do any members have a set of these nipples up for grabs?

Thanks for the heads up guys

20170723_021817[1].jpg

[Agemax]

z1 enterprises sell nice shiny aluminium ones with new O rings, not too expensive either.