Announcement

Collapse
No announcement yet.

Issues starting when cold

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Issues starting when cold

    So I continue to have Issues! But things are getting better. Now the bike won't start in the morning unless I pop start it. Choke is fully engaged, otherwise it runs like a champ. I'm not happy with how the boots sit on the airbox side but I've tested them with starter fluid with no results. Idle fuel screw set to 2.5 turns out. Starts great once it's warm, so my thought is it's not getting rich enough for effective cold starting. Any help would be appreciated! Btw valves are next on my list , could they be causing the issue? Bike is a 82 750t
    Last edited by Guest; 07-31-2017, 03:30 PM.

    #2
    From what I've read, correctly adjusted valves are very important for cold starting.
    Jordan

    1977 Suzuki GS750 (My first bike)
    2000 Kawasaki ZRX1100
    1973 BMW R75/5

    Comment


      #3
      Ok I didn't know that will try to do them this weekend

      Comment


        #4
        "Starts great once it's warm, so my thought is it's not getting rich enough for effective cold starting. Any help would be appreciated! Btw valves are next"

        valve check is a must.... then suspect the small passage that runs from bottom of each fuel bowl up to enricher system, as it often gets clogged
        1981 gs650L

        "We are all born ignorant, but you have to work hard to stay stupid" Ben Franklin

        Comment


          #5
          Three things caught my eye.

          1. I will confirm that tight valves (especially the intakes) will cause hard starting when warm.

          2. Your "idle fuel screw" is the PILOT SCREW, according to Suzuki. Most of us call it a "mixture screw" because it controls a mixture, not just fuel.

          3. Full "choke" might not be the best setting. Right after starting, slowly move your lever toward the OFF position, see if there is a spot where the engine speeds up a bit, then starts to slow down. Note that faster speed position, use that to start the bike, instead of FULL.

          When you adjust your valves, be sure to use the correct procedure for camshaft positioning. It has also been suggested that you use two feeler gauges to check both valves at the same time. This will prevent the rocker arm from tipping sideways a bit, giving you a false reading. Others have mentioned that if your rockers are tipping that far, valve adjustment might be the least of your problems. I do it for peace of mind anyway.

          .
          sigpic
          mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
          hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
          #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
          #2 son: 1980 GS1000G
          Family Portrait
          Siblings and Spouses
          Mom's first ride
          Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
          (Click on my username in the upper-left corner for e-mail info.)

          Comment

          Working...
          X